CEL Power8 workshop Manual de usuario descargar pdf (Pagina 17)

Charging - Additional Safety Rules

Know Your Product

Input:

120V or 240V AC 50/60Hz 46W

Output:

18V DC 1.5A

Charging time: 1 Hour

Specifications

Charging - Specification and Know Your Product

4.1

1. Before using the charger (Handle Dock), read

all the instructions and cautionary markings on

the charger and battery pack (POWERhandle)

as well as the instructions on using the battery

pack.

2. This charger is designed for indoor use only.

Do not charge your batteries outdoors.

3. DANGER: Do not allow any liquid to come

into contact with the charger. There is a danger

of electric shook.

4. The charger is not intended for any use other

than charging the exact type of rechargeable

battery pack as supplied with the charger. Any

other use may result in the risk of fire, electric

shook or electrocution.

5. To reduce the risk of an electric shook, unplug

the charger from the power supply before

attempting to clean it.

6. Do not disassemble the charger. Take it to an

authorised service center when service or repair

is required. Incorrect re-assembly may result in

the risk of fire, electric shook or electrocution.

7. Do not pull on the lead of the charger to

disconnect it from the power source. Do not

carry the charger by the cable. Protect the cable

from sharp objects, heat and oil; have it replaced

if damaged.

4.2

Charging Dock - Operating Instructions

4.3

The POWERhandle has been shipped in a low

charge condition. You should charge the battery

fully before use.

WARNING. Do not throw used POWERhandles

into a fire or water; it could cause an explosion!

NOTE. It is necessary to slide down the product

release latch in order to remove the

POWERhandle from the charger dock, or from

the tools.

To charge the POWERhandle slide it into the

charger dock; the rails of the POWERhandle

should be aligned with the rails of the charger

dock. Slide the battery down until it “clicks” into

position. Connect the mains plug to a suitable

mains outlet.

LED’s on the top of the charger dock

will display the battery’s condition.

When the green LED is on, the case

is correctly connected to the mains

power. A green flashing LED means

fast charging. When the red LED is on,

the POWERhandle is fully charged

Full

Charging

fast ready

Secondary

Charger

Point(SCP)

Charger Dock

POWERhandle

LED Display

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 85 86

Comentarios a estos manuales

Sin comentarios

CEL Power8 workshop Manual de usuario Pagina 17

Comentarios a estos manuales