CEL Power8 workshop Manual de usuario descargar pdf (Pagina 66)

Drill Press - Assembly

11.3

Switching Drill Press On and Off

NOTE: Ensure that all body parts are clear of

the cutting tool before installing a

POWERhandle.

1. To start the machine, press the green

operation button on the main case.

2. The machine will now run continuously.

3. To stop the machine, press the Red operation

Button on the main case.

Drilling a Hole

Fit a cutting tool such as a brill bit into the chuck

as described in point 4.

Adjusting the height of the drill press by lifting

the latches which lock the post in place and slide

the post into the correct location, ensure the

latch is flush with the work surface again before

proceeding.

Select a suitable gear for your cutting tool and

material. Low gear for large drill bits and cutting

metal and high gear for small drills and softer

materials.

NOTE: Drill a test hole in scrap wood before

cutting your work.

NOTE: Put scrap material under the work piece

you are cutting to stop damage to the work

surface.

Warning. Never start the drill press with the

cutting tool on the work piece.

NOTE: Make sure the jigsaw and circular saw

are NOT installed onto the case lid and the

internal plug is NOT connected to a product. The

drill press will not work if the jigsaw or circular

saw are installed or the case lid is shut and

latched.

The drill press is started and stopped by the

main case operation ON/OFF button above the

charger dock.

Start the drill, pull the post lever downwards

slowly

, align your marking with the cutting tool tip

and continue to pull the drill slowly through your

work piece. Let the drill do the work; don’t force

it through or your work will snag.

Return the lever to its upper position, then stop

the Drill. At all times you must ensure your work

piece is held firmly against the work surface.

CAUTION.

Always ensure that the

able Saw is

switched off and the POWERhandle is removed

before any adjustments.

Drill Press - Operating Instructions

11.4

4. Add your required cutting tool to the drills chuck and tighten

firmly. If further height adjustment is required please referee to

stage 3.

5. The post lever can be fitted to either side to allow for left or

right handed use. slide the front pin to the moving part of the post

and the other pin into the elongated hole on the stationary part of

the post. The drill should move down when the handle is pulled

downwards now.

Use the post handle to pull down the drill press and make sure

the drill bit will not touch the work surface when it is fully pulled

down; at this point you may need to adjust the height again.

6. When the drill press is configured as you require assemble a

POWERhandle into the charger dock to enable the product.

7. If using a drill with a tip 10mm or less then

it is possible to use the table clamp to hold

your work. Unwind the clamp knob until the

open jaws can fit over the post and into the

holes. Align the clamp pins into a pair of

holes on the post and tighten the knob again.

Place your work piece on the work surface in

the correct position and further tighten the

clamp until your work is firmly held in

position.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 85 86

Comentarios a estos manuales

Sin comentarios

CEL Power8 workshop Manual de usuario Pagina 66

Comentarios a estos manuales