CEL Power8 workshop Manual de usuario descargar pdf (Pagina 72)

Scroll Saw - Assembly

12.3

5. Close the lid. Snap shut both

the case latches

6. The table clamp can be fitted to

press the work piece against the

work surface. First install the post

into the vertical position at the

highest level. Rotate the

adjustment knob until the open

jaws can be passed over the post.

Align the bar ends to fit onto the

holes on the post and re-tighten to

secure in place. The tighter the

adjustment to the clamp knob the

more pressure is applied to hold

down your work.

7. Only after full installations and

adjustments have been made

should the POWERhandle be

fitted into the charger dock to

enable the product.

8. The Scroll saw is started and

stopped by the main case

operation ON/OFF button above

the charger dock.

Scroll Saw - Operating Instructions

12.4

Making pocket Cuts

1. Use the drill press or drill to bore a hole on the

inside of the area you want to remove, close to

the cutting line. ensure that the drill diameter is

great than the blade with by 1 or 2mm

2. Place the hole over the scroll saw blade and

align the cutting face of the blade with the

direction of cut and your marked line. For this

operation you will have to remove the T

able

clamp or slide your work under neath it. Now

continue to stage 2 of ‘Making Cuts’.

Making T

ight or Corner Cuts

NOTE: Don’t try and cut a curve which is too

tight by forcing the blade. This will put undue

pressure on the blade causing it to snap.

If you intend to make a pocket cut with internal

rounded corners it is best to use the drill press

first with the correct diameter drill.

For external corners continue your cut past the

your mark and then realign the work piece with

the blade facing in the correct direction.

When you get to the tight external corner move

the work piece gently back and forward at the

same time rotating the work in the disired

direction to enlarge the cut width so the blade

can turn enough to align with your marked

direction.

Making Cuts

CAUTION. Always ensure that the scroll saw is

switched off and the POWERhandle is removed

before any adjustments.

1. First insure that you have install the correct

blade into the jigsaw for the material and design

you are about to Cut. Wood blade all types of

Wood and a metal Blade for Metals and plastics.

2. Before starting the scroll saw or installing a

POWERhandle into the charger dock adjust the

table clamp so that the it firmly presses your

work piece against the work surface but still

allows easy movement.

3. Align the first cut with the cutting face of the

blade with a small gap, holding your work piece

with your right hand start the scroll saw with your

left.

4. Grip you work pieces on both sides of the

table clamp and gently push it into the cutting

face of the scroll saw, firmly but smoothly guide

the work over the blade following your marked

design. Depending on the material of your work

piece you might have to blow the dust away to

keep good visibility of your marked cut line.

5. When you have completed you cut hold the

work stead with you right hand and stop the

scroll saw with your left.

Making Bevel Cuts

The jigsaw can be adjusted to lean 10° in either

direction to enable a Bevel cut.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 85 86

Comentarios a estos manuales

Sin comentarios

CEL Power8 workshop Manual de usuario Pagina 72

Comentarios a estos manuales