CEL Power8 workshop Manual de usuario descargar pdf (Pagina 71)

Scroll Saw

4.1

4.2

1. Please also refer to 2.1 - General Safety

Instructions and 7.2 - Additional Safety Rules -

Jigsaw before using this Scroll Saw.

2. This Scroll Saw (model number WS1-TS01) is

only for light duty trimming and cutting. It is not

intended for heavy or industrial use.

Always wear safety glasses with side shields,

and gloves.

Do not install the drill into the post for drill press

function while set up for Scroll Saw function.

Use the work clamp provided to assist you to

gently hold the workpiece on the table while

cutting.

Use only the correct jigsaw blade for materials to

be cut, refer to 7.3 - Jig Saw Operating

10.2

Scroll Saw - Specification

12.1

Scroll Saw - Additional Safety Rules

Specifications

Voltage: 18V

2400 RPM

Max Cutting Capacity:

Metal (10 mm)

Wood (40 mm)

No load speed:

Instructions when necessary. The maximum

blade capacity of this Scroll Saw is 90mm, and

maximum cutting for wood is 40mm.

Never leave the Scroll Saw running unattended.

Turn power OFF by pressing the RED Button

and remove the POWERhandle. Don't leave tool

until it comes to a complete stop.

Provide adequate support to the rear and sides

of the saw table for wide or long workpiece.

Keep hands away from cutting area and blade.

Do not reach around or over the blade while

blade is reciprocating.

Do not attempt to remove off cuts of material

when blade is moving. Never attempt to free a

stalled saw blade without first turning the saw

OFF.

12.2

1. Open Case lid and remove

the all the tools and the carry

tray. Take the jigsaw in your left

hand and push the rear of the

sole plate into the pocket on the

bottom of the Case Lid.

2. Slide back the product lock,

and rotate the front of the

jigsaw into position. When the

sole of the jigsaw is fully in

contact with the metal work

surface release the product

lock. Ensure that the product

lock is fully returned to the left.

3. Remove the internal plug

from its storage area, ensuring

that the cable is free from its

hooks.

4. Slide the internal plug onto

the Jigsaw. Ensure that it is

fully pressed into position.

Scroll Saw - Assembly

12.3

1 2

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 85 86

Comentarios a estos manuales

Sin comentarios

CEL Power8 workshop Manual de usuario Pagina 71

Comentarios a estos manuales