CEL Power8 workshop Manual de usuario descargar pdf (Pagina 18)

Charging - Secondary Charger Point (SCP) 4.4

As well as the main charger dock the

POWER8works is fitted with a secondary

charger point(SCP). This allows a

POWERhandle to be charged while a second

POWERhandle is powering the

POWER8workshop benchtop functions.

When the secondary charger point is removed

from the charger dock, the dock will not charge a

POWERhandle. The secondary charger point

must be correctly replaced into the side of the

charger dock to start charging the

POWERhandle in the dock.

As soon as a POWERhandle is connected to the

SCP, and the mains plug is connected to a

suitable power source, it will start the charging

cycle.

To obtain the best life for the battery:

Never allow the battery to completely discharge;

it should be placed on charge whenever it is

noticeably running down, or the tool no longer

performs a task it previously performed.

Avoid conducting short charges. Make sure that

the battery is fully charged every time by

allowing the charger to complete its full charging

cycle.

Avoid allowing loose items like screws or nails

etc. to be stored with battery packs as this may

cause a fire or explosion.

Always unplug the charger when not in use and

store in a dry, secure place. Avoid charging or

storing your battery in temperatures below 0°C

(32°F), and above 40°C (104°F).

5. Drill/Driver

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 85 86

Sin comentarios

CEL Power8 workshop Manual de usuario Pagina 18