CEL Power8 workshop Manual de usuario descargar pdf (Pagina 52)

10. Table Saw

Case - Post and Accessory Box Storage and Release

9.2

Post Removal

To remove the post from its storage area, first

close the case lid and ensure that the latches are

both locked. Place the case onto its front face

(handle area) the post should be facing you.

1. Grip the moving part of the post head and pull

it away from the case. This will release the

latch and allow the head of the post to rotate

out.

Note: May use the post handle to slide the post

head away from the case easily.

2. When the latch is clear of the recess rotate out

the metal portion of the post to approx 20°.

3. Now slide the post along the bottom of the

case to allow the other post hook to come free

from the POWER8works.

Post Replacement

To replace the post, once again place the case

onto its front face.

Hook the green post hook into the post storage

pocket.

Rotate the post head and push the active post

hook until the latch “clicks” into recess inside the

case.

Accessory Case Release

4. Press the latch on the back of the case (with

the arrow pointing up) upward, then pull the

accessory case by thumb away from the case to

release it.

Accessory Case Release

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 85 86

Sin comentarios

CEL Power8 workshop Manual de usuario Pagina 52